Top Banner

C18 Marine Generator Sets

The C18 is the latest generator and brings commonality with our petroleum products as well as interfacing improvements. We have also taken this opportunity to add new price list options. All engine ratings and emissions certifications are the same, however we have been able to increase the power output of the generator for 12 of the 14 ratings.

C18

GET A QUOTE

A sales engineer replies within one working day.

Request Quote

The Cat® C18 is built for reliable performance in the marine power systems range, backed by Al-Bahar's regional service and support network.

Power Range
260 - 565 ekW
Frequency
50 / 60
Emissions
EPA Tier 3, IMO II, EU IWW, EU Stage V, China II
Configuration
In-line 6, 4-Stroke-Cycle Diesel
Download Brochure
  • Specifications
  • Features
  • Standard Equipment

Specifications

Power Rating specifications
Power Range 260 - 565 ekW

Features

Separate circuit aftercooling system

The primary advantage of the separate circuit aftercooling system (SCAC) is that no sea water circulates through the aftercooler

Emissions

EPA Tier 3 compliant, IMO II and EU IWW compliant

Cooling system

Heat exchanger and Keel cooled options for all ratings

Turbo Configurations

Single turbo configurations for all ratings

Marine Certifications

All major MCS type approvals available from factory

Standard Equipment

Air inlet system
  • Separate circuit after-cooled (SCAC)
  • Open Crankcase Ventilation (OCV) system
  • Turbocharger, jacket water cooled
  • Turbocharger inlet, 152 mm (6 in) OD straight connection
Cooling system
  • SCAC pump, gear driven, for HEX cooled engines only
  • Jacket water pump, gear driven
  • SCAC and JW shunt tanks for maintaining proper pump inlet pressures
Exhaust system
  • Water-cooled exhaust manifold & turbocharger
  • Round flanged exhaust outlet
Fuel system
  • Hybrid fuel line design
  • Fuel transfer pump, gear driven
  • Front service simplex fuel system
  • Manual fuel priming pump
Lube system
  • Center sump oil pan: Deep 500 hour oil change interval
  • Front and top service oil filler locations
  • Front service dipstick
Lube System
  • Oil pump, gear driven
Mounting system
  • Vibration Isolators
  • Formed C-channel rails
Control system
  • Common Interface to all Genset Control Panels
  • Programmable Low Idle
  • Electronic Diagnostics and Fault Logging
  • Electronic Fuel/Air Ratio Control
Control System
  • Programmable ECM Shutdowns for: High Jacket Water Coolant Temp Low Engine Oil Pressure Engine Overspeed

Optional Equipment

Exhaust system

  • Dry Elbows
  • Water-Cooled Elbows
  • Flexible Fitting
  • Flange
  • Muffler

Air inlet system

  • Air Inlet Adapter

Charging system

  • Battery Chargers 10 amp
  • Charging alternator 24V 105 amp

Control system

  • Caterpillar alarm and protection
  • EMCP 4.2 control panel
  • MGCP III B control panel

Fuel system

  • Duplex fuel filter – front service
  • Fuel cooler
  • Primary fuel/water separator

Instrumentation

  • Generator service side - LH, RH
  • Generator terminal box extension
  • Load sharing module (option for type approved module)

Lube system

  • Duplex oil filter
  • Sump pump

Protection system

  • Generator protection - IP44

Starting system

  • Starting motors - electric and/or air
  • Jacket water heaters