Minimum Rating | 1550 eKW (1937 kVA) |
Maximum Rating | 1700 eKW (2125 kVA) |
Frequency | 60 hz |
Speed | 1800 |
Configuration | Vee 12 4-Stroke-Cycle Diesel |
Aspiration | TTA |
Bore | 170 mm |
Stroke | 215 mm |
Displacement | 58.56 l |
Emissions | IMO II |
Length | 5085.3 mm |
Width | 2142.1 mm |
Height | 2131.1 mm |
Weight - Estimated | 12762 kg |
Corrosion resistant separate circuit aftercooler core, regular duty air cleaners, dual turbochargers
Caterpillar A-III electronic engine control, Electronic Unit Injection fuel system, rigid wiring harness
Auxiliary fresh water pump, centrifugal non-self-priming auxiliary sea water pump, gear driven centrifugal jacket water pump, expansion tank, engine oil cooler, thermostats and housing
Dry gas-tight exhaust manifolds with heat shields, dual turbochargers with water-cooled bearings and heat shields, vertical exhaust outlet
Flywheel, SAE No. 00, 183 teeth Flywheel housing, SAE No. 00
Fuel filter, RH, with service indicators
Fuel transfer pump
Electronically Controlled Unit Injectors
Engine mounted instrument panel with four position switch, over speed shutdown notification light, emergency stop notification light, graphical display unit for analog or digital display of: oil and fuel pressure, oil and fuel filter differential, system D
Top mounted crankcase breather, RH oil filter, RH oil filler, gear type oil pump, deep sump oil pan, recommended use of Caterpillar Diesel Engine Oil 10W30 or 15W40
Industrial type engine mounting rails)
Accessory drive Lower RH, Lower LH Front housing, Two-sided
A-III Electronic Monitoring System provides customer programmable engine de-ration strategies to protect against adverse operating conditions
Emergency stop push button (located in Electronic Instrument Panel) Safety shutoff protection for oil pressure and water temperature, over speed protection
Vibration damper and guard Paint, Caterpillar Yellow engine with black rails. Lifting eyes
Air Cleaner Removal
Remote Air Inlet Adapters
Battery Chargers
Charging Alternators
Load Sharing module
Local speed throttle control
Water level switch gauge
Coolant level sensors
Connections
Keel Cooling Conversions
Radiator cooling conversion
Heat exchangers
Auxiliary water pumps
Sea water pump removal
Air separator
Exhaust outlet
Flexible fittings
Elbows
Flanges
Flange and exhaust expanders
Mufflers
Fuel Cooler
Fuel priming pumps
Flexible fuel lines
Rigid Fuel Lines
Primary fuel filter
Fuel level switch
1500/1800 RPM, 1000/1200 RPM
Low Voltage Connection
Generator Conversion
Low Voltage Extension Box
RFI Filter
Bearing Temperature Detectors
Manual Voltage Control
Air Filter
PL1000T Communication Module
PL1000E Communication Module
Customer Interface Box
Thermocouples
Remote panel display
Remote cylinder temperature display
Oil Pan
Oil pan accessories
Sump pumps
Prelubrication Options
Lubricating oil
Centrifugal Oil Filter
Vibration isolators
Rails
Flywheel guard
Flexible coupling
Coupling hub
Front housing accessories
Upper left hand front location
Upper left hand rear location
Upper right hand front location:
Upper right hand rear location
Lower left hand front location
Front housing accessory drives
Front power take-offsFront power take-offs
Crankshaft pulleys
Damper guard removals
Air inlet shutoffs
Switches and contactors
Explosion relief valve
Sensors
Starting motors or barring divice
Air starting motors options
Battery sets - 24 volt - Dry
Battery rack
Jacket Water Heater
Tool set
Caterpillar datalink wire
Commissioning