Power Range | 454-715 bhp (339-533 bkW) |
Speed Range | 1800-2100 rpm |
Emissions | IMO II, EU IIIA |
Aspiration | TA, TTA |
Bore | 145 mm |
Stroke | 183 mm |
Displacement | 18.1 l |
Rotation from Flywheel End | Counterclockwise |
Configuration | In-line 6, 4-Stroke-Cycle Diesel |
Minimum Dry Weight | 1814 kg |
Minimum Length | 1854 mm |
Maximum Length | 19312 mm |
Minimum Height | 1198 mm |
Maximum Height | 1300 mm |
Minimum Width | 1134 mm |
Maximum Width | 1204 mm |
Maximum Dry Weight | 1950 kg |
Separate circuit after-cooled (SCAC)
Open Crankcase Ventilation (OCV) system
Turbocharger, jacket water cooled
Turbocharger inlet, 152 mm (6 in) OD straight connection
Separate Circuit After-Cooling (SCAC) for both HEX and Keel cooled engines
Engine JW and SCAC Shell & Tube Heat Exchangers for HEX cooled engines
SCAC pump, gear driven, for HEX cooled engines only
Jacket water pump, gear driven
Sea water pump, bronze impeller, gear driven
SCAC and JW shunt tanks for maintaining proper pump inlet pressures
Water-cooled exhaust manifold & turbocharger
152 mm (6 in) round flanged outlet
Flywheel Housing, SAE No. 0
Flywheel, 18 inch, 136 teeth
SAE standard rotation
SAE No. 1, Flywheel: 14 inch, 113 teeth
Front service simplex fuel system
Fuel transfer pump, gear driven
Manual fuel priming pump
Hybrid fuel line design
Front service simplex oil system
Center sump oil pan: Deep; 500 hour oil change interval, Shallow; 250 hour oil change interval
Front and top service oil filler locations
Front service dipstick
Oil pump, gear driven
Front support - adjustable
Poly-V groove for alternator drive
NOTE: There are no standard power take-offs available
Front damper guard
Front service engine
Common electrical bonding point
Engine does not ship with zinc components
Engine is certified to D2/E2 emissions cycles
Certified to IMO II Marine Commercial Propulsion (E3) Cycle Emission Standards
Certified to EU Stage IIIA AND CCNR Stage II (E3 Cycle) Emissions Standards.
NOTE: Ratings listed below can also be used in Recreational / Pleasure Craft applications.
Programmable low idle
WOSR (Wide Operating Speed Range) available for EPA Tier 3 - B and C Ratings
Adjustable High Idle (TEL) - EPA Tier 3 WOSR Ratings Only
Electronic diagnostics and fault logging
Engine and transmission monitoring (speed, temperature, pressure)
Electronic fuel/air ratio contro
Engine Protection Mode for extended ambient conditions - EPA Tier 3 Ratings Only
Torque Limiting functionality for WOSR ratings only
70-pin customer connector
Three types of throttle inputs (primary/ secondary PWM, 0-5V, 4-20mA +/-
Dry Elbows
Water-Cooled Elbows
Flexible Fitting
Flange
Muffler
Muffler Spark Arresting
Air Inlet Adapter
Battery Chargers
Charging Alternators
Alternator Mounting Group
Ammeter
MECP I
Caterpillar Alarm System and Protection
AUX Expansion Tank Flange Kit
Duplex Fuel Filters
Flexible Fuel Lines
Fuel Cooler
Primary Fuel Filters
Instrument Panels: Marine Power Display, Color Marine Power Display, Color MPD Dual Display Harness, MPD Wiring Connection Kit
OEM Wiring Harness
Engine to Engine Harness
Gauges
Transmission Sensors
Oil Level Sensor
Duplex Oil Filters
Transmission Oil Cooler
Sump Pump
Vibration Isolators
Front Support
Rear Support
Note: PTO Options Require Torsional Vibration Analysis
Crankshaft Pulleys
Front Stub Shaft
Hydraulic Pump Drive Adapter
Front Enclosed Clutch
Marine Classification Society and SOLAS
Marine Classification Society and Fire Resistance
Electric Starting Motors - Single 24 Volt
Air Starting Motor
Air Start Accessories
Starting Aids - JW Heaters
Battery Sets - 24 Volt - Dry