High Performance Propulsion Engines

  • Specification Summary

  • Power Range 660-705 bhp (492-526 bkW)
  • Speed Range 2300 rpm
  • Emissions IMO II
  • Aspiration TA
product-C12 ACERT High Performance
Cat® C12 ACERT Diesel Marine Propulsion Engines, with ratings of 669-715 mhp (660-705 bhp) at 2300 rpm, meet IMO II emission standards. The C12 takes full advantage of the electronically controlled unit injection fuel system, resulting in an environmentally friendly engine with outstanding performance and fuel economy. There is also a wide range of optional equipment available to meet the needs of your specific pleasure craft application.

Ratings

Power Range 660-705 bhp (492-526 bkW)

Engine

Speed Range 2300 rpm
Emissions IMO II
Aspiration TA
Bore 130 mm
Stroke 150 mm
Displacement 12 l
Rotation from Flywheel End Counterclockwise
Configuration In-line 6, 4-Stroke-Cycle Diesel

Dimensions & Weights

Width 969 mm
Dry Weight 1174 kg
Length 1574 mm
Height 1005 mm

Air Inlet System

 Aftercooler - sea water; corrosion resistant, Air Cleaner/Fumes Disposal (closed system), Turbocharger, Jacket Water Cooled

Control System

 Electronic governing, Cold mode start strategy, Power compensation for fuel temperature, Programmable low idle, Electronic diagnostics and fault logging, Engine and transmission monitoring (speed, temperature, pressure), Fuel/air ratio control, Emergency s

Cooling System

 Thermostat and housing, Jacket water pump; gear driven, Sea water pump; rubber impeller; self-priming; gear-driven, Integral heat exhanger/expansion tank; removable tube bundle; replaceable copper-nickel tubes, Keel cooling - combined circuit (includes pip

Exhaust System

 Watercooled Manifold & Turbocharger

Watercooled Manifold & Turbocharger

Flywheels & Flywheel Housings

 Flywheel; SAE No. 1; 113 teeth, Flywheel housing; SAE No. 1 (10 degree slant pad), SAE standard rotation

Fuel System

 Fuel filer; RH service on Port; LH service on Starboard, Fuel transfer pump, Fuel priming pump, Flexible fuel lines

Lube System

 Crankcase breather, Oil cooler, Oil filter; spin-on; RH service on Port; LH service on Starboard, Oil filler, Dipstick; RH service on Port; LH service on Starboard, Oil pump; gear driven

Mounting System

 Front support

Front support

Power Take-Offs

 Hydraulic pump drive; SAE A; 11 tooth spline, 57 ft-lbs max torque; counterclockwise as viewed from the rear of hte engine looking into the pump drive and turns 1.41 x engine speed, Crankshaft pulley; 345 mm (13.6 in) single groove; 15.88 mm (.63in) width

Hydraulic pump drive; SAE A; 11 tooth spline, 57 ft-lbs max torque; counterclockwise as viewed from the rear of hte engine looking into the pump drive and turns 1.41 x engine speed, Crankshaft pulley; 345 mm (13.6 in) single groove; 15.88 mm (.63in) width

Protection System

 Shutdown; electronic; 12 or 24 volt; energized to run

Shutdown; electronic; 12 or 24 volt; energized to run

General

 Vibration damper, Lifting eyes, RH or LH service options, Literature, Variable engine wiring, Upper rear-facing customer wiring connector and ECAP connection, Electronic installation kit (connectors, pins, sockets)

Vibration damper, Lifting eyes, RH or LH service options, Literature, Variable engine wiring, Upper rear-facing customer wiring connector and ECAP connection, Electronic installation kit (connectors, pins, sockets)

Air Inlet System

 Low Profile Air Inlet Line, Shield (Air Inlet Line)

Low Profile Air Inlet Line, Shield (Air Inlet Line)

Charging System

 Charging Alternators, Voltmeter Guages, Voltmeter Guage Mounting, Alternator Mounting Group

Charging Alternators, Voltmeter Guages, Voltmeter Guage Mounting, Alternator Mounting Group

Cooling System

 Sea Water Pump, Coolant Recovery Tank, Flange Kit

Sea Water Pump, Coolant Recovery Tank, Flange Kit

Exhaust System

 Flexible Fitting, Elbow, Dry Elbow, Watercooled Elbow, Exhaust Connection, Exhaust Outlet Pipe, EXH Outlet Flange, Rain Cap, Muffler

Flexible Fitting, Elbow, Dry Elbow, Watercooled Elbow, Exhaust Connection, Exhaust Outlet Pipe, EXH Outlet Flange, Rain Cap, Muffler

Fuel System

 Fuel Cooler, Fuel Connections, Primary Fuel Filter, Primary Fuel/Water Separator

Instrumentation

 OEM Wiring Harness, Engine to Engine Harness, Digital Tachometer, Tachometer Mounting, Magnetic Pickup, RH 4 Hole Instrument Panel, LH 4 Hole Instrument, Marine Power Display System, Marine Power Display Unit (for additional monitoring stations), Marine Po

Lube System

 Manual sump pump, Transmission oil cooler

Manual sump pump, Transmission oil cooler

Mounting System

 Vibration Isolators

Power Take-Offs

 Crankshaft Pulley, Front Stub Shaft, Front Stub Shaft & Pulley

Starting System

 Air Pressure Regulator, Air Start Silencer, Start Switch, Jacket Water Heater, Battery sets (24 volt - dry)

General

 Wiring Harness Removal, Belt Guard - Alternator, Belt Guard - Alternator Pulley, Filter Cover Kit

Wiring Harness Removal, Belt Guard - Alternator, Belt Guard - Alternator Pulley, Filter Cover Kit

Packing

 Overseas Preservation, Engine Protective Cover, Storage Preservation, Export Packing

Overseas Preservation, Engine Protective Cover, Storage Preservation, Export Packing