Minimum Rating | 1180 ekW |
Maximum Rating | 1825 ekW |
Emissions | IMO Tier I |
Bore | 170 mm |
Weight | 18800 kg |
Aspiration | TUrbocharged-Aftercooled |
Displacement | 69 l |
Stroke | 190 mm |
Oil Change Interval | 1000 h |
Fuel System | EUI |
Engine Control | ADEM A3 |
Height | 2214 mm |
Length | 6095 mm |
Width | 2147 mm |
Cooling System - Engine | 480 l |
Lube Oil System - Refill | 405 l |
Separate Circuit aftercooler core, corrosion resistant coated (air side) Air cleaner, regular duty Dual Turbochargers, 152 mm (6 in) OD straight connection
Caterpillar A-III Electronic Engine Control, LH with Electronic Unit Injector Fuel System Rigid Wiring Harness (10 amp DC power required to drive Electronic Engine Control Module)
Outlet controlled thermostat and housing, full open temperature 92°C (198°F)
Jacket water pump, gear driven
Single water outlet connection, includes flange: 143 mm (5.6")
Aftercooler fresh water cooling pump (SCAC), gear driven centrifugal
SCAC pump circuit contains a thermostat to keep the aftercooler coolant from falling below 30°C (85°F)
Dry gas tight exhaust manifolds with heat shields Dual Turbochargers with watercooled bearings and heat shields Exhaust outlet, vertical, 203 mm (8 in) round flanged outlet
Flywheel, SAE No. 00, 183 teeth Flywheel housing, SAE No. 00
Fuel filter
Fuel transfer pump
Electronically Controlled Unit Injectors
Fuel priming pump, LH
Rigid fuel return line with customer connection point as base of engine
Overspeed shutdown notification light, Emergency stop notification light
Graphical Unit (Marine Power Display) for analog or digital display of:
Crankcase breather, top mounted
Oil cooler
Oil filter and dipstick, LH
Oil pump, gear-type
Oil pan drain valve, 2" NPT female connection
A-III Electronic Monitoring System provides customer programmable engine de-ration strategies to protect against adverse operating conditions
Emergency stop push button (located in Electronic Instrument Panel) Safety shutoff protection:
Air starting motor, RH, 620 to 1034 kPa (90 to 150 psi), LH control
Air silencer
Paint, Caterpillar yellow, with black rails
Vibration damper and guard
Lifting eyes
Engine and generator, three-point mounted to sub-base
Lift provisions on base
Oil drain extension
Engine length drip pan
Remote Air Inlet Adapters
Battery Chargers
Charging Alternators
Load Sharing module
Local speed throttle control
Direct rack control interface, 0-200 mA DC control
Coolant level sensors
Connections
Air separator
Flexible fittings
Elbows
Flanges
Flange and exhaust expanders
Mufflers
Fuel Cooler
Primary fuel filter
Fuel filters
Duplex fuel filters
Fuel level switch
Air filter — generator
Bearing temperature detectors
Cable access box
Manual voltage control
PL1000T Communication Module
PL1000E Communication Module
Customer Interface Box
Remote panel display
Remote cylinder temperature display
Exhaust temperature thermocouples
Discrete I/O module
Intake manifold temperature sensors
Oil temperature sensor
Duplex oil filter
Bypass centrifugal oil filter
500-hour oil pan
Emergency lube oil connections
Oil level regulator
Prelube
Sump pump
Vibration isolators
Auxiliary drive shafts and pulleys
Air or electric starting motor
Redundant start with select switch
Spray shielding
Crankcase explosion relief valve
Metal particle detector
Jacket water heater